PV-KIT FOR ANY PROFILE

PV-KIT  FOR ANY PROFILE from INVENTIVE PRODUCTS PTY LTD

By: INVENTIVE PRODUCTS PTY LTD  03-Jul-2011
Keywords: Solar Energy Systems, Solar Panel, Solar Clamps

Installing pv panels on a flat roof, the normal way would be 2 rails to support 1 panel, if 2 panels are required on top of each other, an additional 2 rails would be needed, not now, all you need is a pv kit installed at the bottom, a pv kit installed in the middle, that same pv kit will also support the second panel, and finally a third pv kit finishes the install, the cost against the normal, using the pv kit connectected to our clamps and pv kit cost around 10cents per watt. On a larger scale installation most Australian roofs, cannot support a tilts system, without the need of addition engineering being carried out on the structure, pure and simple due to the load that will be added to the roof, with our flat installation system, engineering still need to be checked always. in brief, a commercial installation, example 250 megawatt system using a tilt frame, Would cost not be cost effective given the inconvenience of applying additional structural supports to the roof, thus making solar out of reach from potential commercial customers, that's why the pv kit, is the right way to go.      

Keywords: Solar Clamps, Solar Energy Systems, Solar Fittings, Solar Panel,

Contact INVENTIVE PRODUCTS PTY LTD

Email

Print this page

Other products and services from INVENTIVE PRODUCTS PTY LTD

COMMERCIAL ROOF STANDS from INVENTIVE PRODUCTS PTY LTD thumbnail
19-Jul-2011

COMMERCIAL ROOF STANDS

All we need from you.... 1. MAKE AND MODEL, 2. SITE ADDRESS, 3.WHEN YOU NEED IT BY,  


S-5 PRODUCT RANGE from INVENTIVE PRODUCTS PTY LTD thumbnail
01-Jul-2011

S-5 PRODUCT RANGE

DONT SCREW IT... CLAMP IT.....